Er bestaan nogal veel Nedis camera's. Probeer die eens opnieuw in te stellen via AP mode.
Add device (AP mode)
1. Tap “+” on the top right corner. A list of potential products appears.
2. Select the device type you want to add from the list
3. Hold the reset button (or switch the bulb off and on for 3 times) until the indication LED (or lighting
device) flashes SLOWLY (as shown in example)
If the light is flashing quickly, reset again by holding the reset button for about 5 seconds or switching
the light off and on 3 times.
4. Confirm the Wi-Fi network to which the device will be added, enter the Wi-Fi password and confirm.
5. Connect your phone to the device’s Wi-Fi hotspot (SmartLife_xxxx)
6. If asked: confirm to stay connected to Wi-Fi network without internet access
7. Go back to the Nedis SmartLife application to continue installation.
8. Now the device is sent the instructions to connect to your existing Wi-Fi network, make sure your
phone and the device are close to the router to optimize reception.
9. After the product is found and added, rename it so you can easily recognize it.
